Rate it!
|
|
|
|
|
5) Toothpick help pull out of spiral cone, and then attach the cone fingers desired length
|
6) Cone spiral must be the same size
|
7) And now starting to put the flower base, ie spiral glue to each other on a circle
|
8) First, we have a number of 24 cones
|
9) Begin to stick the second row of cones
|
10) Two rows of 24 cones
|
11) Third row of cones
|
12) And the fourth row of cones
|
13) Then flip the resulting workpiece and also begin to stick cones
|
14) That turned our flower base, just turned seven rows, but the number of rows can be changed all at your discretion
|
15) To take a straw stalk for a cocktail, whichever largest hole in the flower you have got tried to create an additional thickness on the tip of the straw or not, in this case, I needed to add thickness to the tip of the strip is 1.5 cm, and apply the adhesive sticking to the straw, cheat.
|
16) Then cut strips of green paper width 5.5 cm and a length of 29.7 cm, folded in half length (twice the pile for slicing fringe turned immediately to the two flowers)
|
17) Do not cut until the end of the fringe cut into approximately 0.4 cm in width, I do it with the "eye". At the tip of a fringe cut out triangles
|
18) Cut lengthwise into halves, one fringe keep it for the next flower
|
19) Toothpick little twirl fringe
|
20) Then take a straw and glue the tip of our fringe to thicken on straw and twirl
|
21) Now combine the base and stalk with Glue
|
22) Lay off the flower inverted to dry
|
23) To take the flower middles strip width of 5 cm, folded in half
|
24) Do not cut until the end. Here's what you should get a fluffy
|
25) Curl up again on a toothpick flower
|
26) Here it is, ready
|
27) It remains only to glue it to the base of the flower pussy!
|
28) Here's our flower ball ready!
|
